No need for splicing, and no need to scrounge around junk yards looking for fuel injector connector pigtails. Just snap the new metal terminals / pins into a brand new nylon fuel injector connector / plug body. You reuse your existing wires first cut off the old metal terminals, and then you crimp the new metal terminals on the existing harness wire. You can dismantle your existing broken fuel injector connector / plug using a terminal release tool (or a very small and thin screwdriver or a dental probe). There is no need to cut your old broken connector off of your vehicle’s wiring harness. Our fuel injector connector kits come with all the parts needed to either replace, rebuild, or repair your broken fuel injector connectors using your existing wiring harness. Whether you’ve broken an old cracked heat damaged fuel injector connector, or whether you are installing new connectors for a new set of high performance injectors on a new engine. In this case, you will have to invest in this problem and deal with it as soon as possible.If you are looking for fuel injector connectors, then you have come to the right place. The engine will start shaking and will lose power. But if the connector is loose and falls off, you will immediately see it. If the connector holds properly, no problems will occur. You can try placing the injector connector back in its place without replacing the connector or the harness. What can happen if I keep driving with this problem? Otherwise, you have to have some experience and knowledge about how the car's electrical system works to avoid any bad damage. Whatever you choose, you will need some parts and also someone to help you with this. Of course, it will take more time and the harness may also cost much more than a clip itself. This is a more expensive but more proper way to deal with the problem. The second option is replacing the whole piece of the wiring harness that connects the injector to other parts of your vehicle. Of course, you should also weather protect your connections properly. This will need some knowledge of car electric systems and how to solder properly. Then you will need to cut the old connector and solder it to the old wires in your vehicle. The first method is to buy a new injector connector with short wires on it. Well, you have basically two choices: the more expensive and the more technically complicated. This means that the vehicle will lose one cylinder and have all the proper consequences for this. It means the connector may easily fall off when you drive, especially if you drive on harsh terrains. They are placed on the top of the engine which continuously shakes and shivers when working. Try putting it in place and taking it off a couple of times and try to see if it's able to work properly.īut don't forget that these connectors work in quite harsh conditions. If your fuel injector connector sits tight and doesn't move to the sides when you place it where it should be placed, it should be OK for some time. So, the next question people ask when they see it's not a 5-dollar breakdown, is whether they can drive their vehicle like that, without investing in repair. This clip is integrated into the connector which in turn is integrated into the wiring. The first question people usually ask in this situation is whether they can replace this clip easily or not. You just pull the harness and the clip breaks after making some sounds. In most cases, this happens when you want to have your injectors cleaned but don't want to pay for labor to have them taken off the vehicle. Usually, the clip will break when you try to pull the wiring harness from the injector. This plastic part just dries out over time and breaks because the plastic deteriorates. You may want to know that thousands of people drive with these clips broken and don't even know about that. This will result in engine misfiring, loss of power, problems with acceleration, engine shaking, high fuel consumption, and other problems.īut it's not always so. It means that if this connector clip is broken, you may experience some problems with signals to the injector and it just may stop working. This is the plastic fixator that holds the fuel injector harness in place allowing the injector to get signals and impulses from other parts of your vehicle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |